Safety, Use, Storage, and Disposal Instructions
Customers acknowledge and agree to the following terms and conditions.
Consumer acknowledges that Seller has made the Instructions, including warnings and safety and health information concerning the Product, efficacy, toxicity, and/or the containers for such Product sold hereunder available to Consumer.
Consumer agrees to promptly and properly disseminate such information so as to give warning of possible hazards, if any, to persons who Consumer can reasonably foresee may be exposed to such hazards, including Consumer’s disseminates, friends, family members, employees, agents, contractors or customers. This product is sharp, and shall be handled and transported with care so as to avoid injury, and is not meant to be used, and shall not be used, as a weapon, projectile, or any other use other than its intended use. TargetTack, LLC will not be held liable for any liabilities resulting from the misuse and misapplication of its products.
SUPPORTED USES
For adhering vinyl and paper-based targets to most commonly used substrates for training, target practice, and shooting sports across archery, firearm, and air-gun trajectories.
IMPORTANT - Substrates or substrate coverings or exterior types currently supported: Cardboard • Plastic Backers • Styrofoam Blocks • Polyfusion Blocks • Poly-wrap Bags and Blocks • Hay Bales • Layered and Dense Foam Blocks
USE
Inserting and removing TargetTack
- Always hold TargetTack by gripping the head with your index finger and thumb with dominant hand.
- While holding the paper-based target with your non-dominant hand on the substrate, point and level the TargetTack Tip towards one of the four corners of the paper target, where your non-dominant hand is safely positioned and firmly press TargetTack through the paper target into the substrate until the bottom of the head is fully secured in position leaving no space between the TargetTack, paper-based target and supporting substrate.
- Some substrates like the plastic backers and poly-wrap bags may require some people to slightly rotate left and right as you apply equal pressure with your index finger and thumb while holding the TargetTack head for easier inserting and removal.
- CAUTION - if needed, turn the TargetTack clockwise a 1/4 inch depending on the substrate to ensure fully secure to the paper target and supporting substrate.
Suspending or holding ONLY cardboard or Styrofoam substrates with three-inch shaft length or greater and less than one pound of total weight.
- With at least a three-inch TargetTack shaft length, a TargetTack may be used to hold or suspend cardboard or Styrofoam substrates by inserting the tip of the TargetTack into the top edge of cardboard or top of the Styrofoam substate through always holding the TargetTack by gripping the head with your index finger and thumb with dominant hand. CAUTION - A 1/4-inch turn may be required to ensure the TargetTack is fully and safely secured. Do not try to hold more than one pound at a time for each of these substrates. Depending on the dimensions of the one pound or less substrates used, it may require two or more TargetTacks to securely and firmly hold or suspend a given substrate in place.
-
The eyelet contained within the head of the TargetTack will allow for string or rope to hang the substrate for ease of positioning in accordance, with SAFETY items 1-14 listed in this Safety & Use Instructions pamphlet.
Recommended use for One or Three Inch TargetTacks with Substrate, Substrate Covering or Exterior Types
- One Inch – Best for Cardboard, Plastic Backers, Styrofoam and Polyfusion Blocks and Poly-Wrap Bags
- Three Inch – Best for Layered Foam Blocks, Straw Butts and Hay Bales
Using Eyelet for affixing tags, labels or ribbons for target identification and acquisition
- Only For Use with light weight string, tags, labels, or ribbons with total weight of two ounces or less.
- Tie knot with the string of choice to a tag, label, or ribbon of choice to the eyelet of the TargetTack head and let naturally hang.
- Ensure that the affixed tag, label, or ribbon does NOT obstruct or cover any part of the target used for target shooting or practice, where archery, firearms and air-gun trajectories are intended to hit.
STORAGE
Store in Original Packaging or Equivalent Packaging
- Always store TargetTacks in either the original packaging initially purchased or an equivalent sealable packaging to minimize losing or misplacing TargetTacks and to keep TargetTacks safe and out of harms way.
- Always keep TargetTacks in sealable packaging stored in a safe and secure location, until ready for use.
- When finished using TargetTacks for adhering paper-based targets to substrate, substrate covering or exterior types, TargetTacks shall be returned to the original or equivalent sealable packaging for storage and safe transporting.
- TargetTacks should remain out of direct sunlight when stored or transported to minimize possible damaging sunlight exposure that may breakdown polycarbonate materials overtime.
DISPOSAL
Disposing of TargetTacks
- Ensure all tacks are in the original or equivalent sealable packaging and are sealed.
- TargetTacks are made from recyclable materials and like other sharp recyclable objects, please use due care when put into a recyclable bin at home or at a recyclable facility.
- Never throw TargetTacks into trash or recycling bins at home or at facility without resealable packaging to minimize injury or unsupervised adult access.
- CAUTION - Unpacked and improperly disposal of TargetTacks my puncture trash bags and other containers.
SAFETY
- Always hold TargetTack by the head, with tip pointed away from your body (See included instruction images) and in a safe direction, that would not harm other people, children, infants, pets and animals or cause damage to property.
- Not recommended for minors under 13 years of age.
- Minors 13 years and older must have adult supervision at all times, read and understand instructions and shown by an adult, before use how to safely and properly use, carry, store, dispose of TargetTacks.
- Never purposely aim at and try to hit any TargetTacks at anytime to further minimize possible ricochets of any type of trajectories.
- Never use TargetTacks on non-supported substrate or substrate covering or exterior types. See above for currently supported substrate or substrate covering or exteriors types.
- Never use TargetTacks, as a weapon or last line of defense.
- Never use TargetTacks to hold or suspend any substrates, other objects or materials except cardboard and Styrofoam blocks, with at least a three inch TargetTack shaft length and less than one pound of total weight.
- Always carry TargetTacks in resealable pouch until you need to adhere a paper-based target to a particular substrate, substrate covering or exterior to avoid accidental injury.
- When storing TargetTacks, reinsert TargetTacks in the original packaging or equivalent sealable packaging, seal package and store in a safe place where minors, children, infants and pets will not have access.
- When using TargetTacks with supported substrates or suspending and holding ONLY cardboard or Styrofoam substrates under one pound, ensure the proper shaft length TargetTack is used and all other safety precautions to include but not limited to federal, state and local laws, statutes, ordinances and posted safety signage be read, understood and followed to ensure the substates being used conform explicitly. If not known, understood or followed, then its strongly advised NOT TO USE TargetTack for this purpose.
- Unpacked and improperly disposal of TargetTacks my puncture trash bags and other containers, that could possibly cause harm.
- This product shall not be placed in one’s mouth, nor be ingested in any way.
- TargetTacks should never be pointed or thrown at any person or thing as such may cause injury.
- TargetTack is not suitable for any other use than its intended use.
WARNINGS
- TargetTacks are for adhering paper-based targets to a supported substrate, substrate covering or exterior type ONLY and does not guarantee targets will remain in place after repeated use. People or persons using Archery, Firearms and Air-guns of any type when adhering targets with our TargetTacks must read, understand and follow federal, state and local laws, statues, town ordinances and posted safety rules before TargetTacks are used to adhere targets to any supported substrate, substrate covering or exterior types. If not known, understood or followed, then its strongly advised NOT TO USE TargetTack for this purpose.
- Possible ricochets of archery, firearms and air-gun trajectories can occur if TargetTack are struck. Never intentionally try to hit any TargetTacks while target shooting with archery, firearms and air-gun trajectories.
- This product has sharp points and small parts in plastic packaging. Possible injury, suffocation and chocking hazards maybe possible, store in a safe and secure location and KEEP AWAY FROM MINORS, CHILDREN, INFANTS, ANIMALS AND PETS. Save instructions and read before each use.
- TargetTack’s product warranty covers ONLY normal wear and use and is limited to one year from the date of purchase for replacement of defective TargetTack. Any TargetTacks damaged by any type of trajectories or mishandling are not covered by this warranty and will not be replaced or refunded. All use, safety, storage and disposal instructions must be followed or the product warranty will be immediately voided without replacement or refunds.
- TargetTacks left exposed to direct weather and sunlight over a period of time may cause product instability and limit durability for repeated use. Proper storage must be maintained to ensure product warranty for up to one year for either replacement or refund, from the date of purchase.
- No one shall tamper with, alter, crush, or otherwise deface the product as such may cause injury and ineffective and improper use.
- This product may contain Bisphynol A (BPA), a chemical known to the state of California to cause birth defects and other reproductive harm. For more information visit www.p65warnings.ca.gov.